![]() ![]() Refer to your manual for CPU installation.ģ. Change the CPU FAN or check if the CPU fan has proper contact with the CPU. Check if the CPU fan is connected to the JCFAN1 connector.Ģ. It does not stop until I disconnect the power supply.ġ. If the same problem happens with the new power supply, you may need to send the BIOS Chip to local dealer for reprogramming. At this point the first thing to try is a different Power Supply to see if the result is better. Try resetting the CMOS using JCMOS1 jumper on the motherboard or remove the battery from the motherboard for 20 minutes. I get a continuous beep (Long and Non-Stop) The data in the BIOS chip is corrupted, Try to reset the CMOS with JCMOS1 or by removing the CMOS battery for 20mins. The power supply could be damaged or bad.ģ. The memory module could be damaged or bad.Ģ. To resolve this issue: This tone is due to a bad component in your system. I get one long and 2 shorts beeps follow by Hi -Lo tone ![]() Please replace the memory (Refer to the memory configuration table in your manual). If you have re-insert the memory a few times and it is still not working, then the memory you have may not be compatible with the board or it has become damaged. Please check and make sure the memory is fully inserted into slot. The beep is indicating that the motherboard did not detect your memory. I get continuous long beeps with short pauses What are the error beep codes for the BIOS and how to resolve the problem? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |